- This topic has 4 replies, 1 voice, and was last updated 16 years, 9 months ago by
.
-
Posts
-
Hi all,
and thank you Mike for your feed back!
my request is how can i configure a voip static route between a DX and a call relay which is registered to a gatekeeper, i did a static route to the call relay but when i make a call, i receive in the call relay log this message: ” IC IP calls ARJ failed (reason=1949464837), and in the dx log a cause=34if you have any idea plz tell may i forget a parameters in my configuration
best regards
I believe I answered this. If you have your quintum units registered to a gatekeeper then static routes will not work. You would need to create the route in your gatekeeper.
The reason for this is that you have told the quintum to use a gatekeeper for all routing. Once configured this way, the quintum will only accept routing information from the gatekeeper.
Without knowing your application, I cannot tell if you really need the gatekeeper or not, but if you can get away from the gatekeeper, then you can configure static routes in the sr area of the dx.
MikeM
mike_voip@hotmail.comHi Mike,
My architecture is did by:
Pbx –> DX – (implement static routes)-> Call relay –> GK
all i need is to configure a static routes between the dx and the call relay
thanks
Mario,
If the DX is NOT registered to the GK, then you should be able to create a static route to the call relay directly. If you simply want all calls to go there, just use the wild card * in the sroute (all defined in the CLI reference guide).
Mike
thank you Mike
i will test this parameter
- The forum ‘Voice over IP’ is closed to new topics and replies.
