- This topic has 4 replies, 1 voice, and was last updated 12 years ago by
.
-
Posts
-
Hi,
I am setting up the following VoIP service using a Cisco 5350 IP Gateway:
PSTN (Intl.) – VoIP – PSNT (UK)
Calls originate overseas, converted to VoIP by clients Gateway, then delivered to our Cisco Gateway where we deliver the calls to UK landline or mobile over PSTN.
I need help to confugure the Cisco 5350 to facilitate the above. are there any default configs that I can apply to get us off the ground?
Many thanks.
Most important you will need a dial-peer to send outgoing calls to your PSTN lines. Search for “PortaBilling100 Handbook: Postpaid Services”, there is a Cisco configuration guidelines for the service which (I guess) is very similar to what you are trying to do
try this out; i am not sure if something is left out
isdn switch-type primary-net5
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-31
description Link To Telcointerface FastEthernet0/0
description Link to Internet
ip address a.b.c.d c.d.e.f
h323-gateway voip interface
h323-gateway voip bind addr a.b.c.dinterface Serial1/0:15
isdn switch-type primary-net5ip route 0.0.0.0 0.0.0.0 w.x.y.z
voice-port 1/0:D
compand-type a-lawdial-peer voice 1 pots
destination-pattern 00025641T
port 1/0:Ddial-peer voice 7 voip
session target ipv4:p.q.r.s
codec g729br8Hi,
l’ve problem on my cisco5350 ;
l reciev the calls via cisco5350–and—hypermedia gateway ,but l can not hear the person who call me , and this person don’t hear me .
l need help to configure the cisco 5350.Best regards
Hi nadyr,
“l can not hear the person who call me , and this person don’t hear me”
I think you should post your 5350 config here so we can review it first.
Asep
- The forum ‘Voice over IP’ is closed to new topics and replies.
