- This topic has 4 replies, 1 voice, and was last updated 18 years, 5 months ago by
.
-
Posts
-
i need to know can some body help what command is used to test a call from A800 to anolg line or numbers.
Regards
Sohail,
You can use the test command to test the PSTN lines for dial tone and then dial a number, but you will not be able to talk or hear voice using this test.
The syntax for the test command is;
test o x (where x is the pstn line number). This will test to see if there is dialtone or not.
test d xxxxxxxx (where x is the digits to dial) will dial out the number you specify.
test e will end the testing.
thanks mike for this help will same command work for AXT 800 quitum gateway
Hi mike i am try to conect tenor configuration manager with AXT800 but unable to connect it give mesaages access denied.
regards
1. The command for 2nd generation is put a debug in front. Like ‘debug test o x’
2. Make sure that you have the correct conf manager version for the software version in your tenor.
- The forum ‘Voice over IP’ is closed to new topics and replies.
