Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

A800 – PSTN to IP Config?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 30th June 2005 at 10:09 #29705
    JK
    Guest

    Hi,

    I have Quintum A800 (SIP Firmware)
    I need to send incoming calls at PSTN port to IP Address using SIP…is it possible??? If yes then help in configuration will be highly appreciated.

    thanks

    JK

    1st July 2005 at 07:48 #29706
    Teodor Georgiev
    Guest

    yes, it is 100% possible.
    Go to Quintum website, download their documentation, read it, learn it and do it.

    1st July 2005 at 14:03 #29707
    JK
    Guest

    Alright. I got the documents and now I am able to route the incoming calls (PSTN) to IP.
    but now the problem is:

    When the caller Hang up the call, my PSTN Line remains busy.
    even the LIGHT at PSTN port is not blinked which means (As I think) Quintum is not using the Line. but line remains busy until I plug out the cable from PSTN port and plug back in.
    The IP Address where I route the calls doesnt have any connectivity with the Line either.
    so who is holding my line? I am sure it is quintum. any help will be highly appreciated.

    thanks

    1st July 2005 at 15:24 #29708
    MikeM
    Guest

    JK,

    Again, go to the Quintum site and review the document on disconnect supervision.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.