Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

R2 problem

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 19th May 2004 at 20:41 #27176
    Alaa Musa
    Guest

    Dear All:

    I have 4 E1s and i used R2 signalling between my gateway AS5300 and PSTN , the problem is i can’t make any call out of my PSTN.

    If i dialled a number in the same PSTN it works fine , but if i dialled a number at other PSTN it gives me busy.

    I don’t think the problem from my PSTN casue i have a land phone line from the same PSTN and it dialled to any other PSTNs

    please advice

    21st May 2004 at 19:58 #27177
    Joel Kepaou
    Guest

    Can you be little more specific,
    for what I understand I will advise you to verify the configuration of your E1.
    1-Be sure that you have correctly setup the end point configuration support all your NNX.

    2-If there is no restriction in the Cisco and you still get a busy tone verify the configuration and limitation of your E1 at the CO Level.

    But by experience I will suggest you to pay an extra attention to the configuration in the Cisco.
    Depending what type of Gatekeeper you use it may send you the answer between deny or busy.

    Good luck
    you can reach me at jkepaou@sun.net.bb if you need more help

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.