VoIP bandwidth calculator...
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

lucent MVAM g/k and cisco g/k interop

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 24th July 2003 at 02:30 #24838
    bob
    Guest

    I am trying get Lucent MVAM gatekeeper to work either with a CISCO g/k or Opensourse GK and I am having problems.

    The LUCENT MVAM rejects the LRQ from both cisco and Opensourse g/k

    Can anyone plse help as how the config should be ??

    6th August 2003 at 16:01 #24839
    Richard
    Guest

    Hi This is Richard From Seoul

    I Run VoIP solution company
    anyway ..

    you can’t do that cause Lucent MVAM use Non_Standard Data and Check MVAM Licence when LRQ send or Receive

    anyquestion feelfree send e-mail

    good Luck

    11th November 2005 at 15:16 #24840
    Outlooker
    Guest

    I just received a basic license for MVAM 3.0.

    I found I could change serial number in C:\winnt\mvam.dat such as MVAM-300-AN-01234567 and run mvam.exe again, there seems nothing wrong. so I think there is no license checking subroutine in MVAM.exe doing MD5 encrypt like license.exe but MVAM reads license from mvam.dat directly.

    I have no way to fully test,as I have no installation disk MVAM 3.0.

    So will anyone who has MVAM installed try to connect two MVAM by modifying MVAM.dat ‘s license.

    By the way, lucent’document says a third party 96 ports gateway could register with MVAM 3.0. if it is true, could cisco call manager 3.x-4.x register with MVAM?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘Voice over IP’ is closed to new topics and replies.