2g huawei

by switch on HBP function , the interference of the system will be slightly raised. but hopefully this can decrease the amount of handover failures and handover losts. so,the use of this function depend on how the increased interference will affect the network.

hi bijoy,

is there any other parameter thr which i can improve the hosr?

i tried ho boos tpower but i got the 50-50 percent result so plz tell if any new one?

and can u tell me something abt huawei 3 power control?

Hi buddy,

k thanks can u plz explain something abt power control huawei2 ? how it works?

and can u tell me something abr gb utilization ? how to check and how to calculate?

Hi
My apologies for delayed response.

Huawei II Power control is based on MR compensation, prediction filtering and adjusting the power step based on the receive level/quality
1. Power control based on the receive level

If UL/DL RX_LEV Upper Threshold < UL/DL receive level < UL/DL RX_LEV Lower Threshold, power control is not required. If the condition is not met, power control is required. If the receive level is less than UL/DL RX_LEV Lower Threshold, the power needs to be increased. Power increment = (upper threshold + lower threshold)/2 – receive level. If the value exceeds the value of MAX Up Adj. PC Value by RX_LEV, take the value of MAX Up Adj. PC Value by RX_LEV instead.If the receive level is greater than UL/DL RX_LEV Upper Threshold, the power needs to be decreased. Power decrement = receive level – (upper threshold + lower threshold)/2. 2. Power control based on the receive quality If UL/DL Qual Upper Threshold < UL/DL receive quality < UL/DL Qual Lower Threshold, power control is not required. If the condition is not met, power control is required.If the receive quality is equal to or greater than UL/DL Qual Lower Threshold, the power needs to be increased. Power increment = MAX Up Adj. PC Value by Qual.If the receive quality is less than UL/DL Qual.Upper Threshold, the power needs to be decreased. Power decrement = MAX Down Adj. PC Value by Qual. Br\\ Bijoy

Hi bijoy,

great man thanks for information if i want to tune power control parameter of this huawei then which parameter i should go for?

and man i have one doubt about gprs,edge at a time how many tbf can continue? it is 16 (dl) + 7(ul) or out of 16 9 for dl+7 for ul?

and round trip time is calculated from its from (1)gprs attach request to gprs attach request establish or

(2) upto pdp context activation?

and last question if i want to inprove my uplink and downlink tbf sucess ratio then n3101,n3103,n3105 parameter will help? sorry for too many questions…………

waiting……….

Hi bijoy,

are u there?
ur help require……….

Hibijoy,

hey buddy i have discussed with one trainer he was telling that at a time pdch can handle total 9 tbf in ul + 7 in dl. but as with discussed with u and my knowledge it is at a time 16 in dl + 7 in ul is it k?

and he was explaining for this frame structure so if possible plz clarify?

and can u tell me how n3101,n3103,n3105 i means its significance?

and in huawei we have formula for tbf sucess is ul tbf attempts(for gprs+edge)+ dl tbf attempts (gprs+edge) / ul tbf success(for gprs+edge)+ dl tbf success (gprs+edge) .so is it ok because here after esblishing tbf if its drop then its not coming inn picture so can u help?

Hey bijoy,

great man plz share if possible……