Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

why do we consider RXQual in DL Level HO

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 7th February 2010 at 10:45 #61000
    RadFreq
    Guest

    Can any one plz clarify that why do we consider RXQual if we are talking about Level HO which has nothing to do with Quality (if i’m not wrong)
    Thank you in advance

    7th February 2010 at 13:12 #61001
    Pix
    Guest

    RadFreq : which equipent is it ?
    the handover algo are very dependant from the vendor…

    pix

    7th February 2010 at 17:16 #61002
    Bijoy
    Guest

    Hi RadFreq
    I think you r talking of Huawei systems,If that is the case Level Ho doesn’t consider RX Qual.Level HO specifies whether the layered hierarchical handover is enabled. Cells are set to different layers and different priorities to implement the layered hierarchical handover. Then, based on the layers and priorities, calls are handed over to the cells with high priority (priority is related to Layer of the Cell and Cell Priority).

    Br\\
    Bijoy

    8th February 2010 at 07:10 #61003
    Pix
    Guest

    In Alcatel systems,

    the HO Lev takes place only when Lev is bad and Qual is good. There is indeed a check on the Quality.
    But that’s just because in case of Bad Qual, it is the HO Qual which is triggered.

    You should ensure that one and only one HO cause can be trigger in each situation.

    pix

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.