Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

LAYER 3 MESSAGES

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 29th September 2009 at 09:10 #58990
    ROOKIE
    Guest

    Does any one could help me know how to read layer 3 messages on drivetest logs?

    Your help is highly appreciated.

    19th October 2009 at 16:17 #58991
    Uday joshi
    Guest

    Hi Rookie,
    can U tell me, which DT tool You are using. To read layer 3 massage, Try using EXPORT WIZARD S/W

    20th October 2009 at 08:40 #58992
    Fresh Opt
    Guest

    Hi,
    My question is the same. We use Agilent E6474A. How can I export all Layer 3 messages. I tried with export wizard, but there are only few messages I can see. Please help!

    20th October 2009 at 15:52 #58993
    Uday joshi
    Guest

    Hi,
    try exporting short call file.
    In the Long call file, messages will not be capture properly.
    You can also select “New export plan” and select the required filter. Also try expanding “Layer 3 header” colomn.

    21st October 2009 at 13:23 #58994
    Fresh Opt
    Guest

    Hi joshi,
    The only columns I can export from Layer 3 are:
    Cell ID,BCCH, BSIC, LAC, Mode, TimeSlot, ARFCN, MAIO, Hopping Flag, HSN, Link Type, Logical Channel, TI/SI, Primitive, IEI Message, Parameters, IEI, TDMA Frame Number.
    IEI Message is empty. I exported a short call file, still nothing. What I’m doing wrong?
    Regards,
    Fresh Opt.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.