- This topic has 4 replies, 1 voice, and was last updated 15 years, 5 months ago by
.
-
Posts
-
Dear all,
have You sometimes problem with transit calls from Cirpack. Out transit exchange EWSD (SW ver. 14) send IDR – Identification Requst and Cirpack do not send IRS – Identification Response) and calls are released.
Have You any any idea?
Thanks a lot.Dear, Peter!
Try to check on your EWSD parameters of the ROUTE which is selected when routeing calls from Cirpack. If you have LNDES parameter (in route) = ANIRQD + DATIMM + RELANIF, then your exchange will send release to Cirpack, if A-number is not available.Dear Pan,
thanks a lot of for Your advice. I learned IN “Command manual for ver. 14”, command MOD ROUTE, parameter LNDES:RELANIF RELEASE ON ANI FAILURE
Specifies that a call shall be released when a
request A-number identification (ANI) has failed.I didn`t wont release call without CLI but I want switch call without CLI to final destination.
I apologize if I bad explained problem.Peter
Hello, Peter!
Enter in command line of your EWSD switch DISPROUTE: ROUTE=//your route// and see output. If LNDES parameter = …..ANIRQD,DATIMM,RELANIF…. then modify this route by means of MODROUTE command (LNDES without ANIRQD,DATIMM,RELANIF).Hi Pan, all routes in our EWSD are without parameters ANIRQD + DATIMM + RELANIF
I think that would be better if You send me your email address . My email is peter.cermi(at)gmail.com and I could send You picture with descrition of problem.
- The forum ‘Telecom Design’ is closed to new topics and replies.
