Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Feature of Dynamic SDCCH

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • 2nd April 2009 at 18:17 #56706
    MKT
    Guest

    Hi all,

    Pl clarify ..

    Whether the Dynamic SDCCH is a feature at BSC level or Cell level.

    Regards

    3rd April 2009 at 14:41 #56707
    ATTO
    Guest

    Hi MKT,

    logically (my logic) the Dynamic SDCCH is a feature at BSC level.
    It is necessary for the BSC to support this feature because it is the one that allocate channels. He knows the configuration at any moment of its cells and decide whether channel is SDCCH or TCH depending on load. HE MUST SUPPORT this feature to do it.

    At BTS level it is just for configuration purpose.It allows BSC to only know if it is possible to use channel in SDCCH or TCH mode.

    Best regards.

    3rd April 2009 at 15:58 #56708
    Jacky
    Guest

    i would like to ask about the TRX mapping on TCUC @ Alcatel BSCs. if i’am right the TCUC can handle 32 SDCCH channels. is there any feature or issue to handle TCUC SDCCH overload?

    3rd April 2009 at 16:12 #56709
    MKT
    Guest

    Ok, agreed.
    That BSC must support the feature .
    But somebody told me that feature is enabled or disabled at BSC level, all the cells connected to the BSC will start behaving as per the defination of dynamic sdcch.

    6th April 2009 at 17:01 #56710
    ATTO
    Guest

    Hi MKT,

    Perphaps implementation depends on vendors specific. Some vendors could block this feature till u purchase it.

    All i know is that BSC can’t apply dynamic SDCCH allocation on cell level when no timeslot have been defined as SDCCH/TCH dynamic allocation capable.

    Thanks !

    7th April 2009 at 20:29 #56711
    Pix
    Guest

    ATTO & MKT,

    The timeslot configuration is done per cell. For isntance, timeslot 3 of TRX2 is configured as SDCCH Dynamic, for one cell.
    And then some other were not configured with sdcch dynamic… etc.

    The feature itself is an OMC-R feature, which allows the cells within the OMCR to be configured with SDCCH Dyn.
    The BSC supports it, obviously, but it is not part of the configuration or the activation process.

    29th March 2011 at 08:34 #56712
    Ajmal Aryanpoor
    Guest

    Hi All,

    the function is BSC & CELL level and need to activate in CELLS which the SD congestion is high, but threshold is BSC level.

    1st July 2017 at 11:19 #56713
    AMB
    Guest

    Can some one mention which parameter value to change for Huawei vendor.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • The forum ‘Telecom Design’ is closed to new topics and replies.