Free Erlang traffic calculators

The world's first online Erlang traffic calculators

Telecom Traffic Online
  Home | Free calculators | Products | Tech. papers | Forum | About us
A-Z termination - click here
A-Z termination - CLICK HERE
A-Z termination using H.323 and SIP
A-Z termination
  • VoIP softswitch

    DUAL Softswitch is a complete Voice over IP switching and billing solution.  Flat monthly rate.

    Web control panels; Least Cost Routing; Excel tariff uploads; SIP and H323 support.

    H323 SIP softswitch >>

  • VoIP calling

    Premium quality termination for wholesale carriers with their own VoIP switch.

    44Direct >>


    Our lowest rates for wholesale carriers with their own VoIP switch.

    44Mobile >>


    Our unique online callshop billing system.

    Bill My Calls >>

in-building walk test with TEMS

Egaru - 4th April 2018  (09:11 GMT)

Please is it possible have continuous pin points so i dont need to keep clicking to make samples, can walk then pin point a few samples and the KPIs are uniformly distributed

SHELDON - 12th July 2010  (20:04 GMT)

I think it's a question of the kind of TEMS kit you have. For the walk test, you need to connect only the phone and dongle, which I believe can be reasonably managed. You can even ask someone to help you out if you can't manage alone. I don't see the necessity of buying a handy kit (for hundreds of dollars maybe) when you can manage with a little bit of difficulty.

Regards,
SHELDON

ahmed - 12th July 2010  (18:26 GMT)

without tablet pc or touch screen it will be so hard to do the job as i used to do this job before as it is impossible to carry laptop and tems kit and walk and click on tems, even with tablet touch pc it is hard :)....go for a handy or pocket kit

SHELDON - 12th July 2010  (09:49 GMT)

Hi Poncho,

You don't need a touchscreen. Once you've loaded your floor plan, locate your position and start pin-pointing(using whatever pointing device ur laptop uses, be it mouse or touchpad).

Regards,
SHELDON

poncho - 12th July 2010  (09:08 GMT)

Hi Ahmed,
Thanks for your reply. Does it mean you can't get it done with a normal laptop without a touchscreen?
Thanks.

ahmed - 11th July 2010  (20:16 GMT)

yes you can ; just load the floor plan bitmap as a layer and click the pin layer and mark on the map as long as you walk ...it will appear as a black dots, keep click continuously to get more samples as much as you can...then save the log and go to the mapinfo to analyze the data.......you need touch screen tablet PC.

poncho - 11th July 2010  (15:37 GMT)

Hi,
Is it possible to have an in-building walk-test with TEMS investigation without GPS connected and yet be able to have the RXLEV foot-print showing in TEMS during the analysis? If yes, how?
Thanks.

Y.

Post a reply to this article

Name Enter your name.
Message Enter your message.
Email Optional -  If you enter your email address in this box, then you will automatically be notified if anyone replies to your message.  Your email address will only be published if you pay to post this message.
Verification
Please confirm you are human.
Press the button to post your message.
Home | Free online calculators | Products | Technical papers | Forum | Contact us | About us

Last modified: 17 May 2017

Copyright 2017. All rights reserved.