- This topic has 4 replies, 1 voice, and was last updated 14 years ago by
.
-
Posts
-
Please help to provide information on Reselect Hysterysis ? Which things & KPIs should be taken into a/c while planning this ?
Check the number of location updates in cells which are at the border between two LACs.
If number is too high, increase the CRH.
If increasing CRH has no effect, then you should consider re-designing your LACs.-pix
thanks pix,is there any other parameter.
Fresher,
There are 400 other parameters.
But none of them will modify the behaviour of LAC borders.
the cell reselect offset will be applied on all neighbours, instead of only the “other LAC” neighbours… but apart from that, the effect is comparable (favour/handicap other cells)both should be used in parallel.
-pixWe have a very new site in our network, which is situatated at LAC border. One of the cells are showing High CSBR and SDBR. What parameters should I check to eliminate these problem. This is a ericsson site. Other LAC situted site is also ericsson. Please respond ASAP. It is affecting the BSC KPI as well as.
- The forum ‘Telecom Design’ is closed to new topics and replies.
